Wholesale Marine - Boating Supplies and Marine Accessories Superstore

How to Use the Pela 650 and the Pela 14K
1) Warm up the oil by running the engine. This will allow the contaminates to mix and to suspend in the oil. Remove the dipstick.
Note: If you can’t hold the dipstick comfortably in your hands, then the oil is too hot! Wait for the oil to cool off a bit.2) Select and insert the appropriate diameter extraction tube into the dipstick pipe until it touches the bottom of the oil pan. Connect the main tube to the top of the unit and to the extraction tube.

3) Pump the handle 4 to 15 times in a row to start the vacuum. The unit will extract the oil automatically. Continuous pumping is not required.

4) After all the oil has been extracted, press the release valve located at the top of the unit for 5 seconds. Remove the main tube. When pouring the oil into a container, hold the pump as in the photo and pour gently. Bring the used oil to a recycling depot.

Pela 14 K

Pela 650

The information provided here has been reproduced courtesy of Pela Products. Wholesale Marine reproduced this information on 10/08/08.

This entry was posted on Wednesday, October 8th, 2008 at 2:44 pm and is filed under How To Guide. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.