Ventilation

Making sure your bilge blower is operating properly is very important, Bilge blowers are available in 3 and 4 inch size, and are designed to remove the dangerous fuel vapors from the engine compartment and fuel tank area. The basic setup for the boat would be to have the cowl or side vents on opposite sides of the boat one facing forward the other aft. Blower hose should be attached to these vents and lowered into the bilge. The hose for the vent facing forward will have nothing attached. It’s designed as the boat is moving forward to scoop and push the air into the bilge. The side with the vent facing backwards is the side that the bilge blower will be attached to. Many installations will has a hose on each end of the blower allowing more options as were to place the blower. When replacing a bilge blower or the vents make sure the air flow is in the proper direction otherwise the bilge will not vent properly. Safety comes first when dealing with gas vapors if in doubt consult and expert, and please remember always run your blower for 5 minutes before starting your engine.

Items 1 to 10 of 45 total

per page
Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Set Descending Direction
  1. Sea Dog Hose Thru Vent

    Sea Dog Hose Thru Vent

    Starting At: $3.76

  2. Perko Chrome Louver Locker Ventilator
  3. Marine Products Fuel Vent Hose 5/8"
  4. Rule In-Line Bilge Blower For 4" Ducting

    Rule In-Line Bilge Blower For 4" Ducting

    $30.44

    These blowers offer efficient high volume air flow along with the following features: - Quiet operation - Low amp draw - Slip on inlet and outlet ducting connections - Sealed motor shaft for moisture protection - Corrosion resistant nikel plated motor housing - ABYC-H2 - ISO 9097:8846 - IMCI (CE) - N.M.M.A. type accepted - USCG 183.410 Compliant, Ignition protected Replaces Jabsco ITT-30500-0000 One Speed Rule IN-Line Bilge Blower Learn More
  5. Sea Dog Stainless Steel Recessed louvered Vent
  6. Sea Dog Stainless Steel Louvered Vent
  7. Sea Dog Stainless Steel Flush Thru Vent

    Sea Dog Stainless Steel Flush Thru Vent

    $24.12

    Stainless steel flush thru vent Learn More
  8. Attwood Louvered Marine Plastic Venturi Vent
  9. Attwood Water-Resistant Turbo In-Line Bilge Blower

    Attwood Water-Resistant Turbo In-Line Bilge Blower

    Starting At: $21.62

    Attwood Water-Resistant Turbo In-Line Bilge Blower Learn More
  10. Perko Chrome Clam Shell Vent

    Perko Chrome Clam Shell Vent

    Starting At: $5.61

    ClamShell Vent manfactured by Perko Chrome. Learn More

Items 1 to 10 of 45 total

per page
Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Set Descending Direction