APPLICATION DATA METHOD: Spatula / Putty Knife
DRY FILM THICKNESS PER COAT: 63.5 mils
COVERAGE: 25 sq. ft/gal.
APPLICATION TEMP: 45°F Min. / 95°F Max.
THINNER: Do Not Thin
|| 5 HR
Note: At 7°C/45°F the pot life is 30 mins and the product is sandable after 24 hrs, immersion after 6 days.
METAL: Above water: Pre-prime with Viny-Lux Primewash 353/354. Apply one coat of Epoxy Primekote. Sand surface with 80-120 grade (grit) paper, wipe clean. Apply Watertite*. Below water: Prime with Interprotect 2000E or Interprotect 3000.
BARE FIBERGLASS: Clean with Fiberglass Surface Prep YMA601 or Fiberglass Solvent Wash 202. Sand with 80 grade (grit) paper. Remove sanding residue.
APPLICATION INFORMATION: Mix in a 1:1 ratio by volume it is important to ensure the correct volume mix ratio is used. Mix the two components thoroughly to an even colour. Do not use below 7°C. Do not apply more than ¾" thickness at any one time. Product temperature should be minimum 10° C/50°F and maximum 35°C/95°F. Ambient temperature should be minimum 7°C/45°F and maximum 35°C/95°F. Substrate temperature should be minimum 7°C/45°F and maximum 35°C/95°F. Apply using a trowel, spatula or putty knife. When the product has cured, wash with fresh water and sand with 80 grade (grit) paper. Apply to clean, dry, properly prepared surfaces only. Watertite* must be overcoated with VC Tar, VC Performance Epoxy, Interprotect 2000E/2001E or Interprotect 3000/3001. Do not apply topside finishes, polyester or vinylester materials over Watertite*.