APPLICATION DATA METHOD: Brush, Roller
NUMBER OF COATS: Atleast 2
COVERAGE: 400 sq. ft/gal.
THINNER: 974 Thinner
ESTIMATED DRY TIMES: Bottom paints are designed for overcoating after an over night dry. Prior to launching, allow a minimum dry of overnight. If drying conditions are poor, or if paint was applied too thickly, longer periods of drying will be required. Fresh coats of paint must be thoroughly dry before overcoating.
PREVIOUSLY PAINTED SURFACES: Scrub bottom clean at haul-out. Repaint only if old paint is sound and tight; if not, remove it by sanding or with paint remover. If old paint is rough, sand it with 100-150grit sandpaper. Prepare seams, nicks and chips as below. Spot coat any scuffs with antifoulant. Apply 2 coats of antifoulant.
BARE FIBERGLASS: Dewax by washing with Dewaxer–973, remove dissolved wax at once with clean papertowels or rags; repeat; sand hard to a dull finish with 80-100grit sandpaper. Fill any chips with trowel cement, dry hard, sand. Apply 3-5 coats of 8000A/8000B Bottom Protect High Build Epoxy Primer, then apply 2 coats of antifoulant.
BARE WOOD: If seams are not flush, fill them with seam compound. Dry several days until skin forms. Do not sand. Fill nicks with trowel cement, dry hard, sand, apply antifoulant (reduced10%) then follow with 2 additional unreduced coats of antifoulant.
STEEL HULLS: Sandblast surface to a near white metal; remove blast residue with a broom and air hose. Wipe off with Dewaxer–973. Do not sand. Fill in any imperfections with fairing compound. Sand smooth and wipe clean. Apply 3-5 coats of 8000A/8000B Bottom Protect High Build Epoxy Primer, then apply 2 coats of antifoulant
APPLICATION INFORMATION: For use on boats below the true waterline. Can be brushed or rolled on fiberglass, wood, aluminum & steel and previously painted surfaces per application systems below. Apply atleast 2 coats for best performance, as the life of the paint is proportional to the number of coats applied. Surface must always be clean, dry and properly prepared prior to painting. Failure to do so will lead to eventually blistering and/or peeling. All sanded surfaces must be wiped clean with Dewaxer–973 to remove sanding residue.