Interlux Nautical Super ProGuard Antifouling Paint
Description
Interlux Nautical Super ProGuard Antifouling Paint
Sold in Gallons
ProGuard is performance, value and reliability all in one. ProGuard is a hard modified epoxy, low V.O.C., high copper antifouling paint formulated to effectively provided year round protection in warm waters or where fouling is at its worst. ProGuard can be applied directly over most properly prepared antifouling paints. Recommended for use on the underwater areas of fiberglass, wood, and properly primed metal (except aluminum) boat hulls and can be used in fresh, salt and brackish waters.
- Hard modified epoxy
- Long lasting year round performance
- High copper, for excellent performance in high fouling waters
- Compatible over most antifouling paints
- Low V.O.C.
Specifications:
- Finish: Matte
- Number of Coats: 2 coats, 3 on bare wood
- Coverage: 470 sq. ft/gal
- Application Methods: Brush, roller, airless and conventional spray
Colors Available:
Do not use on aluminum.
***WILL SHIP GROUND ONLY TO THE CONTIGUOUS 48 STATES ONLY***
How to Apply
APPLICATION DATA METHOD: Airless Spray, Brush, Conventional Spray, Roller
NUMBER OF COATS: 2, 3 on bare wood
DRY FILM THICKNESS PER COAT: 2 mils (3.5 mils wet)
COVERAGE: 470 sq. ft/gal.
APPLICATION TEMP: 50°F Min. / 95°F Max.
THINNER: Special Thinner 216
Temp | To Touch | To Recoat | To Launch |
95°F | 30 MIN | 1 HR | 6 HR |
73°F | 1 HR | 2 HR | 8 HR |
50°F | 2 HR | 6 HR | 12 HR |
PREVIOUSLY PAINTED SURFACES - GOOD CONDITION: Remove all traces of loose paint by sanding the entire surface with 80 grit wet-or-dry sandpaper; wipe surface clean with Xylene¹ using the two-rag method before and after sanding. Apply two coats of Super ProGuard allowing for appropriate dry times.
BARE FIBERGLASS: Scrub the surface thoroughly with a stiff brush using soap and water. Flush with fresh water to remove the soap residue and allow surface to dry. Remove mold release wax and surface contamination by wiping down the surface with Xylene¹ using the two-rag method. Fill any surface imperfections with approved filler for underwater use. Sand the entire surface with 80-grit sandpaper until a flat matte finish is obtained. Wipe the sanding residue off the surface with Xylene¹ using the two-rag method. Apply two coats of Super ProGuard allowing for appropriate dry times.
BARE WOOD: Sand the entire surface with 80 grit wet-or-dry sandpaper; wipe surface clean with Xylene¹ using the two-rag method before and after sanding. Apply the first coat of Super Proguard thinned 10% with Xylene². Apply two finish coats of Super Proguard allowing for appropriate dry times.
APPLICATION METHODS:
California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov
PRODUCT REVIEWS
QUESTIONS & ANSWERS
Other Details
- Google Product Type:
- Antifouling
- Wiser:
- Yes
- Paint Type:
- Ablative Antifouling
- Number of Seasons:
- Single Season
- Antifouling Type:
- Copper Based
- Hull Material:
- Fiberglass, Steel, Wood
- Water Type:
- Brackish Water, Fresh Water, Salt Water