Interlux Micron WA Antifouling Paint
Interlux Micron WA is a showcase antifouling paint that offers long-lasting, multi-seasonal protection in a water-based formulation. Micron WA combines powerful antifouling performance while reducing the impact on the environment. This bottom paint leaves a smooth, clean hull. Ideal for cruise, power and sail boats and is suitable for all waters.
Unique Water Activated Matrix Technology: Ensures a crisp, vibrant color and uniform finish while delivering powerful antifouling protection.
Excellent Protection: The latest in enhanced technology that combines powerful antifouling performance with outstanding protection in all waters.
Easy to Apply: Easy to use with brush or roller, indoors or outdoors, and has low odor and VOC omissions. Fast drying times for year-around use and launch. Micron WA delivers a polished, smooth surface that minimizes the prep for the next application and is easy to clean up.
Environmentally Responsible: The solution for boat owners looking for protection, performance and fuel efficiency.
- Area: Below the waterline
- Finish/Sheen: Matte
- Suitable for Aluminum: No
- Suitable for High Fouling Areas: Excellent
Application Methods: Brush, Roller
Number of Coats: 2-3 [Bare Wood: 3 coats, first thinned]
Coverage: 375 sq. ft/gal
|Immersion||48 hrs||8 hrs||6 hrs||6 hrs|
|Touch Dry||3 hrs||1.5 hrs||1.5 hrs||30 mins|
Previously Paint Surfaces in Good Condition: Remove all traces of loose paint and contamination by sanding the entire surface well wil 80 grit sandpaper. Remove sanding debris.
Previously Painted Surfaces in Poor Condition: Completely remove all old antifouling paint using Interstrip 299E for fiberglass and wood, and by sandblasting to near white metal for steel.
Bare Fiberglass: It is very important that bare fiberglass by properly prepared to prevent delamination of the antifouling paint. Remove mold release wax using Fiberglass Surface Prep following the product label instructions. Fill any surface imperfections with Interlux Watertite following the label instructions. After the surface has been properly prepared, follow one of the application systems below:
Bare Fiberglass No Sanding System: Clean the surface following the preparation procedure above. Apply 1 coat of Interprotect 2000E. Follow the instructions on the label or data sheet of the primer used. Apply at least two coats of Micron WA allowing appropriate drying times.
Bare Fiberglass w/ Sanding System: Clean the surface following the preparation procedure above. Sand with 80 grade paper. Remove sanding residue. Apply at least two coats of Micron WA, allowing appropriate drying times.
Bare Fiberglass w/ Blister Prevention System: Clean the surface following the preparation procedure above. Sand with 80 grade paper. Remove sanding residue. Apply Interprotect 2000E to a thickness of 10 mils.
Bare Wood: Sand with 80 grade paper. Remove sanding residue. Apply the first coat of Micron WA thinned 10% with water. Fill seams, if necessary, with Seam Compound Brown 30. Apply 2 more coats of Micron WA unreduced, allowing the appropriate dry times between coats.
Do not use on Aluminum.
Customers also viewed