Mission Delta Wakeshaper

Mission Delta Wake Shaper

The Delta Wake Shaper is optimally designed to create a world-class wave in the smallest possible package. Mission's Delta Wakeurf Shaper will deliver a great wave on almost any boat with the right ballast setup and Delta attached in the right location. Wake shapers work by disrupting the flow of water, opposite of the surfer, causing turbulence that diffuses the power that stream once had. The result is a surf wave with a clean, undisturbed face that is easy to surf. The Delta makes waves even better on boats with factory surf tab systems.

Key Features:

• Durable Design - reinforced high grade polymer; anodized aluminum and stainless steel. It floats!
• Switch Sides in Seconds - symmetrical design allows Delta to work on both sides of the boat.
• Reversible - front panel reverses so you can fine-tune the wave on your boat.
• Clean Attachment - attaches in seconds and removes without a trace.
• Maximum Grip - oversized suction cups provide plenty of holding power.

How to Install:

• Delta installs on the opposite side of the boat from the surfer.
• Look for a 5x13" smooth location about 2-4" below the waterline when fully ballasted and at surf speeds.
• The location must be free of decals. Position your Delta as far back as possible.
• If you have very little ballast, it is recommended that you unscrew and reverse the orientation of the front panel so that it is positioned even further back.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov