Garelick I-O Swim Platform with Fold Down Ladder

HOW TO MOUNT GARELICK OUT BOARD I-O SWIM PLATFORM WITH FOLD DOWN LADDER

Assembly Instructions:

• Mount hand rails to platform by inserting 4 bolts through holes in platform. Secure with 4 locknuts.
• Mount SS strut 22” by inserting bolt through hole and secure with locknut.
• Mount SS strut 11” by inserting two bolts through holes and secure with 1 locknut.
• Choose most suitable side of transom for mounting platform. Turn motor unit as far as possible to that side. Make a line on the transom indicating motor unit’s full extension to that side.
• Position platform away from drawn line at desired mounting location, parallel to the water line, and mark 4 mounting holes through flattened ends of rails and/or struts onto the transom.
• Drill four marked holes with a bit compatible with selected fasteners (fasteners not provided). Hold drill perpendicular to transom when drilling.
• If transom is less than 2” thick, it is recommended that a backing plate be mounted on the inside of transom.
  • NOTE: The backing plate should be made of either aluminum, marine plywood or some other suitable non-compressive material.
• Coat the mounting surfaces of the rails and/or struts with a marine grade adhesive/caulking compound; squeeze a small amount into mounting holes in transom. Insert selected bolts through holes and secure in position with suitable fasteners.

Maintenance:

• Periodically check mounting hardware and re-tighten (due to normal boat operation).
• Regular fresh water rinsing and periodic cleaning with a mild abrasive cleaner will help retain luster and help prevent corrosion.

Information sourced from Garelick Assembly Instructions for Platforms Technical Data 

Installation Instructions