Jabsco 37202 Shower & Bilge Pump 12v

Jabsco Shower Drain and Bilge Pump

Flow rate: Nominal 13 Litres/min (3 USgallons/min)

Self-priming from dry up to 2m (6ft)

• Flow Rate: 3 GPM, Port Size: 3/4"
• Nominal Voltage: 12 Volt DC, Max. Current Draw: 8 Amps, Fuse: 10 Amp
• Ignition Protected, Supplied with Pumpgard StrainerQuiet running and fully corrosion resistant.
• Supplied with pumpgard filter.
• Permanent magnet motor
• Self-priming
• Compact and simple design
• Dry running capability
• Permanent magnet type motor
• Meets ISO 8846 MARINE ignition protection

Installation Instructions:

• Fit pump in a dry position, as close as possible to the liquid being pumped, where there is full access to the pump for service. 
• Use 3/4" i.d. spiral reinforced hose (with a smooth internal bore), or semi-rigid pipework systems. 
• Note: Pipe runs should be as straight and as short as possible, avoiding riding and dipping over obstructions.
• Fit pumpguard on inlet side of pump.
• All marine pumps discharging overboard must be installed with the overboard discharge well above both static and heeled waterlines (Sailboats normally discharge through the transom).
• Motor cases may get hot. Prolonged contact during operation may cause burns.
• Note: Do not use for pumping petrol, petroleum products, or fluids with flash points below 98.6 degrees Fahrenheit.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov