Ancor Heavy Wall Marine Battery Cable Heat Shrink Tubing

Ancor Heavy Wall Marine Battery Cable Heat Shrink Tubing

• Cross Linked polyolefin tubing is much stronger than PVC tubing and will not burn like PVC. 
• Heat activated, heavy walled, adhesive lining provides impervious seal to salt water, oil, acids, and sunlight
  as well as providing strain relief. 
• Highest shrink ratio - shrinks to 1/3 original size.
• Shrinks at 257° F/125° C. 
• Operating temperature range of -40° C to 110° C.
• 3" LONG BY 3/4" DIAMETER
• 2 per pack

Frequently Asked Questions

What is the Attwood Marine Battery Strap made from?

The Attwood Marine Battery Strap is made from woven polypropylene and features firm-grip buckles. The strap is completely resistant to battery acid.

How is the Attwood Marine Battery Strap installed?

Installation involves routing the strap under the clamp opening with the buckle positioned properly on top. The battery box is then placed over the clamps, and after the battery is installed, the strap is buckled over the cover.

Where should the clamps for the Attwood Marine Battery Strap be mounted?

The clamps should be centered lengthwise on the battery box so they fit into the bottom groove. Mount the clamps on a flat surface of the boat floor using the supplied template and screws.

Is the Attwood Marine Battery Strap resistant to battery acid?

Yes. The woven polypropylene strap is completely resistant to battery acid, making it suitable for use with the applicable battery box installation.

What should be checked when positioning the Attwood Marine Battery Strap buckle?

When routing the strap under the clamp opening, make sure the buckle is positioned properly on top. After the battery is installed, buckle the strap over the battery box cover.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov