CMC High Speed Hydraulic Power-Lift Transom Jack - 5-1/2" Set Back
CMC High Speed Hydraulic Transom Jack is ideal for fresh or salt water use. Made of 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners. This transom jack has no welds or castings to break. The CMC Hydraulic Transom Jack has a dependable, self-contained and waterproof hydraulic actuator that has a maximum lifting capacity of 7853 pounds of thrust. You will have no problem lifting even a V-6 300 HP Max motor at full throttle.
The hydraulic actuator in this transom jack is mounted inside the structure of the jack, but is still accessible without removing the engine. There are no hoses contain, and no need to mount a pump and reservoir inside your boat. The hydraulic actuator is completely self-contained with its own fluid reservoir. The cylinder within the actuator has twice the lifting capacity than other transom jacks on the market. Features a no-leak seal and wiper that keeps dirt and water out of the working parts.
CMC Hydraulic Power-Lift Transom Jack's roller design means less friction, longer wear, less maintenance, and virtually no binding problems that are common with other transom jacks. The roller assembly contains a stainless steel 3/4" pin with aluminum-bronze alloy rollers. Rollers are highly impact resistant, corrosive resistant, and have a high load carrying capacity.
Gives 5" of vertical travel with 1-1/2" of adjustment on the motor bracket and 1-1/2" of adjustment on the transom bracket. A total of 8" of possible adjustment.
- Does Not Comes with Gauge
- 5-1/2" Set Back
- Maximum Lifting Capacity of 7853 lbs of thrust.
- Will raise V6 300 HP and smaller outboard motors in approximately 8 seconds!
- Ideal for those who want a jack plate for high speed positioning of their outboard motor!
- Mounting Hardware Included
- Not designed for V8 motors
- (1) Hydraulic Power-Lift unit
- (1) Wire assembly
- (4) 1/2" -13 x 3 stainless steel hex head cap screws
- (4) 1/2" -13 stainless steel hex nuts
- (4) 1/2" stainless steel lock washers
- (4) 1/2" stainless steel flat washers
- (1) Up down toggle switch
Find Similar Products by Category
Customers also viewed