Garelick Wing Step Ladder - Anodized Aluminum Frame
- Strong, lightweight anodized aluminum construction
- Easy Boarding for Swimmers or Divers with fins or heavy gear
- Steps fold "parallel" in automatic unison for storage
- Dual aluminum center vertical rails for stable support while boarding
- Optional storage brackets available for stowing folded ladder
- Comfortable Ergonomic Designed Step- Black reinforced nylon with traction molded curved surface
- Heavy Duty - rated to 400 lbs. (181kg) boarding weight
- Stainless Steel mounting bracket includes "Kick-up" feature if boat takes off with ladder in down position
These models include transom mounting bracket (99195: 2.5"W x 3.75"H (6x10cm) Includes 1" thick poly spacer with locking pin and stainless steel face plate. Mounting hole diameter is 5/16"
- 3 STEP MODEL: Stowed Dimensions: 4"x4"x42" (10x10x107cm), Length Deployed: 34" (86cm), Width: 15" (38cm)
- 4 STEP MODEL: Stowed Dimensions: 4"x4"x51.75" (10x10x131cm), Length Deployed: 44" (112cm), Width: 15" (38cm)
HOW TO MOUNT GARELICK GULL WING BOARDING LADDER
- Choose the most suitable side of transom for mounting ladder.
- Locate a place on the transom where the ladder will mount and not interfere with the turning and lowering operation of your motor. Determine the actual waterline when the boat is at rest. Mark this location in both the horizontal and vertical direction.
- Locate the ladder on this mark and slide it up to the desired mounting height. It is optimal to have at least two steps in the water for ease of boarding.
- Mark the ladder’s potion at the top of mounting bolt.
- NOTE: This line will locate the top two holes for the mounting plate.
- Check the inside of the transom where the mounting is proposed. Verify that there is ample space to install a backing plate (minimum size 4” x 5 ½”) that will support the ladder installation.
- A 4” x 5 ½” minimum flat area or the size of your backing plate is required for a secure installation.
- NOTE: The backing plate should be made of either aluminum, marine plywood or some other suitable non-compressive material
- Mark four mounting plate hole locations on your transom or transom extension bracket using the plate as your template.
- NOTE: This ladder has an adjustable feature that may accommodate the desired angle; if not, it may be necessary to make an external shim or modify the mounting substrate to achieve the proper ascent angle (5 to 10 degrees) for your ladder. Drill one 11/32” or 3/8” hole through your transom, noting the angle of the mounting substrate hole. These holes are perpendicular to the mounting face plate, not the transom. When drilling, this hole angle should be used to insure a proper installation. Place the mounting substrate and faceplate against the boat and loosely mount it with the hardware that you have selected for proper installation.
- Level the bracket, mark and drill the next hole. Check the ladder for level, make adjustments if necessary and then drill the other two holes.
- Put a bead of adhesive caulk around the perimeter of the mounting holes and all edges of the mounting substrate, coat the bolt threads with anti-seize compound and secure the mounting substrate in place by tightening all four mounting bolts.
- Both the 3 and 4 step ladders open in a similar fashion.
- Rotate one of the steps counter-clockwise to open the ladder.
- Rotate one of the steps clockwise to close the ladder.
- To adjust the angle of the ladder with respect to the mounting surface, remove nut and bolt and adjust the angle for comfort and ease of use.
- Do not use when motor is running.
- Check all steps and hardware before using/
Information sourced from the Garelick Installation Instructions for Models 19853/19854/19873/19874 “Gull Wing Step” Boarding Ladders
Find Similar Products by Category
Customers also viewed