Total Price:
Add to CartBoat motor mounts have several uses. Primarily these extensions are used to convert from a propeller-driven craft to a jet drive. An alternate purpose allows the extension to be mounted on shallow running boats that are already equipped with a tunnel extension. In this application, the vertical boat motor mount is attached to the hydraulic Power-Lift. In either application, the vertical extension enables the motor to be mounted up to 5-inches higher than the standard mounting on the transom. T-H Marine’s boat motor mounts are constructed from a heavy-gauge extruded aluminum alloy that resists corrosion and offers long wear. Here are some additional specifications for the CMC 5 Inch Motor Mount Vertical Extension:
Motor Mount Vertical Extension Features:
California Residents: 
WARNING
Cancer and Reproductive Harm -
P65Warnings.ca.gov
Other Details
CMC Bottom Transom Washer Plate Features: Made from strong 3/8" 6061 T6 Alloy Aluminum. (Not cast Aluminum) Transom washer can eliminate bolts "biting" into transoms and can more evenly distribute...
Add to Cart
CMC Top Transom Washer Plate Features: Made from strong 3/8" 6061 T6 Alloy Aluminum. (Not cast Aluminum) Transom washer can eliminate bolts "biting" into transoms and can more evenly distribute loads...
Add to Cart
T-H Marine CMC PT-130 Electric Hydraulic Tilt and Trim The CMC PT-130 is a tilt and trim unit designed for use with 130HP motors and smaller. Constructed from 1/2" 6061 T6 extruded aluminum with...
Add to Cart
CMC PT-130 Electric Hydraulic Tilt and Trim with Gauge Features: Rated for 130 HP and Smaller Motors. 6" Set Back to Enhance Boat Stability and Performance. 20 Degrees of Trim and a Total of 90...
Add to Cart
CMC Hydraulic Power-Lift Transom Jack 5-1/2" Set Back Features: No Gauge Included Model PL-65 Rated for V-6 and Smaller Motors Provides 5" of Vertical Travel Not designed for V8 Motors or...
Add to Cart