Attwood Ski Mirror Wide-View

HOW TO INSTALL ATTWOOD SKI MIRROR – WIDE-VIEW

Needed for Installation:

• Phillips head screwdriver
• Small flat-head screwdriver
• (2) #10 stainless panhead screws (for surface mounting)
• Drill and suitable drill bit (for surface mounting)

**When deciding on a location for your mirror, ensure that it does not block forward vision**

Bracket Mounting Instructions

Windshield Mount

• Place the bracket over the windshield frame and clamp by tightening the two setscrews that are installed in the base. DO NOT OVER TIGHTEN
• On windshield frames less than 5/8” thick, place a rigid spacer between the setscrews and the frame.

Flat Surface Mount

• Select a suitable location making sure that the holes can be drilled without damaging hidden wires, ect.
• Place bracket in desired location and mark hole locations.
• After drilling holes, install bracket with #10 screws and tighten securely.
• After surface mounting, remove the two setscrews from the base.

Mirror Mounting Instructions

• Insert the tab on the back of the mirror into the slot in the bracket. Orient the mirror to the desired position, making sure that both setscrews are making contact with the tab.
• Tighten the setscrews enough to hold the mirror in place. Ensure the mirror is correctly placed and has sufficient adjustment to accommodate users of different heights.
• Fully tighten setscrews. DO NOT OVER TIGHTEN
• Adjust the mirror to the desired position. Lightly tighten bolts on the back of the mirror.

Note: If mirror moves during use, tighten bolts further.

Information sourced from the Attwood Ski Mirror Installation Instructions