Johnson/Evinrude Pre-1979 400A Control Cable Connection Kit

SeaStar Johnson/Evinrude Pre-1979 400A Control Cable Connection Kit by Dometic

Connection kits for the 400 type cables from 1973-1978 with bare wire. Used with TEL-CC170xx cables, OMC, Johnson and Evinrude Engines. Kit CA27208P comes with 2 ends. Kit CA27247P comes with 1 end.

Direct replacement for Teleflex Marine original factory control cable fitting. SeaStar Solutions replaced Teleflex Marine and has been acquired by Dometic Group.

Fits:

• CA27208P - Pre 1979 engine connection kit for 400A (Bare Wire) cables for 35HP & down Evinrude/Johnson Outboards.
• CA27247P - Pre 1979 engine connection kit for 400A (Bare Wire) cables for over 35HP Evinrude/Johnson Outboards.

Frequently Asked Questions

What is the SeaStar Johnson/Evinrude Pre-1979 400A Control Cable Connection Kit designed for?

The SeaStar Johnson/Evinrude Pre-1979 400A Control Cable Connection Kit by Dometic is designed for 400A bare-wire control cables used with OMC, Johnson, and Evinrude engines from 1973 through 1978. These connection kits are used with TEL-CC170xx cables and provide the engine connection fitting for the applicable control cable setup.

Which Evinrude and Johnson outboards use the CA27208P connection kit?

The CA27208P is the pre-1979 engine connection kit for 400A bare-wire cables used with Evinrude and Johnson outboards rated at 35 HP and below. Verify the engine horsepower and cable application before selecting this connection kit.

Which Evinrude and Johnson outboards use the CA27247P connection kit?

The CA27247P is the pre-1979 engine connection kit for 400A bare-wire cables used with Evinrude and Johnson outboards rated over 35 HP. Confirm that the engine is a pre-1979 application and that the control cable is a compatible 400A bare-wire type.

What is the difference between CA27208P and CA27247P?

The two kits are differentiated by the engine horsepower application and the number of connection ends included. CA27208P is for 35 HP and down Evinrude and Johnson outboards and comes with 2 ends, while CA27247P is for engines over 35 HP and comes with 1 end.

Are these connection kits direct replacements for the original Teleflex Marine fittings?

Yes. The connection kits are direct replacements for the Teleflex Marine original factory control cable fitting. SeaStar Solutions replaced Teleflex Marine and was subsequently acquired by Dometic Group.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov