Mercury 92-802878-55 Corrosion Guard

Mercury 92-802878-55 Corrosion Guard

Use Mercury Corrosion Guard to protect your outdrives and lower units from rust. Corrosion Guard is a rust inhibitor that forms a water-resistant barrier on painted and non-painted surfaces. This formula remains clear after it dries and doesn't peel. Corrosion Guard can be used on outdrives, lower units, power trim motors and components, and other metal surfaces. It can also be used to prevent further paint damage in areas where undercutting and blistering have occurred.

Features:

• 11oz. Spray can
• Protects outdrives, lower units, and other metal surfaces
• Remains clear & doesn't peel
• Safe for painted surfaces

*Note: Do NOT use on surfaces coated with antifouling or biocide paint. Do not spray on drive belts.

How to Use Mercury Corrosion Guard

Use when air and can temperature is between 50°F and 80°F and humidity is 60% or less. Avoid spraying in very windy or dusty conditions. Cover surrounding area to protect from spray mist.

• Remove all dirt, wax grease, saltwater deposits, and other contaminants with a high quality cleaner. Rinse with water and allow area to dry.
• Shake can well for one minute after mixing ball begins to rattle. Shake often during use.
• Hold can upright 8-10 inches from surface and apply thin, even coats using a steady, uniform, back and forth motion. Keep the can in motion while spraying. Release button after each stroke.
• Dries to the touch in 20 minutes, to handle in 1 hour, and fully dry in 24 hours.
• Reapply before storing your boat and every week if boating in salt water areas.

When finished spraying, clear spray valve by turning can upside down and pushing spray button until clear gas comes out. Clean up wet paint with mineral spirits. Dispose of empty can in accordance with local, state, and federal regulations.

Frequently Asked Questions

What is Mercury 92-802878-55 Corrosion Guard used for?

Mercury 92-802878-55 Corrosion Guard is a rust inhibitor designed to protect outdrives, lower units, power trim motors and components, and other metal surfaces. It forms a water-resistant barrier on painted and non-painted surfaces and dries clear without peeling.

Can Mercury Corrosion Guard be used on painted surfaces?

Yes. Mercury Corrosion Guard can be used on painted surfaces and remains clear after drying without peeling. However, it should not be used on surfaces coated with antifouling or biocide paint.

How should Mercury 92-802878-55 Corrosion Guard be applied?

Clean and dry the surface before application, then shake the can well. Hold the can upright 8–10 inches from the surface and apply thin, even coats using a steady back-and-forth motion. The recommended air and can temperature is 50°F to 80°F with humidity of 60% or less.

How long does Mercury Corrosion Guard take to dry?

Mercury Corrosion Guard dries to the touch in 20 minutes, is ready to handle in 1 hour, and fully dries in 24 hours. The product should be allowed to dry according to these specified times after application.

How often should Mercury Corrosion Guard be reapplied?

Mercury recommends reapplying Corrosion Guard before storing your boat and every week when boating in saltwater areas. This product is designed to provide a water-resistant protective barrier against rust and corrosion on applicable metal surfaces.

Where should Mercury 92-802878-55 Corrosion Guard not be used?

Do not use Mercury Corrosion Guard on surfaces coated with antifouling or biocide paint, and do not spray it on drive belts. When applying the product, cover surrounding areas to protect them from spray mist and avoid spraying in very windy or dusty conditions.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov