Application and Use for Interlux Flattening Agent
Product Description
A Flattening Agent specially formulated for mixing with Interlux’s 1-part finishes, Toplac, Brightside, Yacht Enamels and varnishes (Original, Goldspar and Schooner) to produce a variety of gloss, satin or matte effect finishes. For interior and exterior use.
Area- Above waterline
Finish- Matte
Thinner-Y216
Number of Coats-Variable
Method of application-Brush, Roller or Conventional Spray
Available colors-Translucent
Pack sizes-1 US Quart
Compatibility/Substrates-Only suitable for use with 1-part finishes or varnishes
Preparation
Follow the surface preparation instructions shown on the label of the finish or varnish to which the Flattening Agent is being added.
Mixing Details-Typical Gloss Reduction using Flattening Agent YMA715,
Parts Finish or Varnish,Parts Flattening Agent, Gloss Range
3 -1 High Semi-Gloss
1 -1 Semi-Gloss
1 -2 Low Semi-Gloss
1 -3 Flat
Method
Stir individual products prior to mixing. Pour required quantities of Flattening Agent YMA715 and finish into a separate container and stir well before use.
Hints
Thinner-Special Thinner 216.
Thinning-Thin 5 percent with Special Thinner 216 if required.
Conventional Spray-For spray application of flattened varnishes or finishes, follow instructions on the datasheet for the product in question.
Other The addition of Flattening Agent YMA715 to a finish or varnish will not affect the drying or overcoating characteristics of the product. It will not affect the durability of the finished surface. As with all the types of reduced-gloss coatings, the resulting finish will not have the same stay-clean properties as a full-gloss coating. If all the mixed (matted) material is not used it may be used at a later date. Simply stir well before use.
Some Important Points
The level of gloss will decrease where the amount of Flattening Agent YMA715 is increased. The opacity (ability to hide) of the chosen finish will be affected once the clear Flattening Agent YMA715 is added. For better hide apply the unflattened finish first and finish off with the mixed (flattened) material as a last coat, or apply the unflattened finish until opacity is achieved. Stir well before use. If all of the mixed material is not used it may be saved and used at a later date. Product temperature should be minimum 15 C/60 F and maximum 30 C/86 F. Ambient temperature should be minimum 5 C/41 F and maximum 35 C/95 F. Substrate temperature should be minimum 5 C/41 F and maximum 35 C/95 F.
The information provided here has been reproduced courtesy of Interlux. Wholesale Marine reproduced this information 08/10/2009