Lenco XDS Trim Tab Actuator 1.25" Stroke

Lenco 15122-001 XDS Trim Tab Actuator 1.25" Stroke

Lenco XDS Actuator. All mounting hardware is included. 6' Wire Included.

• 12V
• Stroke - 1-1/4"
• End - 3/8"
• Top Cap - 5/16"

Replaces OEM Part # 20740-0035

Lenco XDS Trim Tab Actuator FAQs

Will the Lenco 15122-001 actuator fit my boat?

The Lenco 15122-001 may be the correct replacement if your existing trim tab system uses a 12V XDS actuator with a 1.25-inch stroke, 5/16-inch top mounting hole, and 3/8-inch end mounting hole. It replaces Lenco OEM part number 20740-0035. Confirm all specifications before ordering, since similar-looking Lenco actuators may use different stroke lengths or mounting configurations.

What Lenco part number does this actuator replace?

The Lenco 15122-001 XDS actuator replaces OEM part number 20740-0035.

What is the stroke length of the Lenco 15122-001 actuator?

This XDS trim tab actuator has a 1.25-inch stroke. Stroke length should be verified against the existing actuator before selecting a replacement.

What mounting-hole sizes does this Lenco actuator use?

The actuator uses a 5/16-inch top-cap mounting hole and a 3/8-inch end mounting hole. Both mounting points should match the existing installation.

Is the Lenco 15122-001 a 12V or 24V actuator?

The Lenco 15122-001 is a 12V trim tab actuator. It should only be used with a compatible 12V trim tab system.

What is included with the Lenco 15122-001 actuator?

This replacement actuator includes the required mounting hardware and a six-foot wire.

Are Lenco trim tab actuators interchangeable?

Not all Lenco actuators are interchangeable. Voltage, stroke length, actuator type, mounting-hole sizes, and replacement part number should all be checked before ordering. A replacement that looks similar may not fit or operate correctly.

How do I identify my existing Lenco trim tab actuator?

Look for the identification or branding information on the face of the existing actuator near the Lenco label. Compare the actuator type, voltage, stroke length, mounting-hole sizes, and OEM part number with the replacement specifications. See our Lenco trim tab actuator identification guide for additional help.

Can I replace only one Lenco actuator?

A single actuator may be replaced when the new actuator matches the existing trim tab system and the actuator on the opposite side is still operating correctly. Inspect both actuators, the trim tabs, wiring, controls, and mounting hardware before completing the repair.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov