Lenco XDS 1.25" Stroke Replacement Trim Tab Actuator

Lenco 15120-001 XDS 1.25" Stroke Replacement Trim Tab Actuator

Lenco's XDS trim tab actuator is a replacement part for your trim tab system. Lenco's ballscrew design creates a more reliable trim tab actuator that is twice as powerful compared to typical hydraulic actuators.  This trim tab kit contains all necessary mounting hardware along with a 6' wire. This actuator has a 3/8" top and end hole.

Lenco Actuator Specifications:

• Stroke - 1.25"
• Hole - 5/16"
• Wire Length: 6'

Lenco XDS Replacement Actuator FAQs

Will the Lenco 15120-001 actuator fit my boat?

The Lenco 15120-001 may be the correct replacement if your existing trim tab system uses a compatible XDS actuator with a 1.25-inch stroke and six-foot wire. Confirm the actuator model, system voltage, mounting-hole sizes, stroke length, and existing part number before ordering because similar-looking Lenco actuators are not always interchangeable.

What is the stroke length of the Lenco 15120-001 actuator?

The Lenco 15120-001 XDS replacement actuator has a 1.25-inch stroke. The stroke length should match the existing actuator and trim tab installation.

What is included with the Lenco 15120-001 actuator?

This replacement actuator includes the necessary mounting hardware and a six-foot wire.

What type of actuator is the Lenco 15120-001?

The Lenco 15120-001 is an XDS electric trim tab actuator designed as a replacement component for a compatible Lenco trim tab system.

How does the Lenco ballscrew actuator design work?

Lenco uses an electric ballscrew design rather than a hydraulic system. According to Lenco, this design provides reliable operation and produces twice the power of typical hydraulic actuators.

Are Lenco XDS trim tab actuators interchangeable?

Not all Lenco XDS actuators are interchangeable. Stroke length, voltage, mounting-hole configuration, wire length, actuator model, and replacement part number should all be verified before ordering.

How do I identify my existing Lenco trim tab actuator?

Locate the identification or branding information on the actuator near the Lenco label. Compare the actuator type, stroke length, voltage, mounting-hole configuration, and part number with the replacement specifications. See our Lenco trim tab actuator identification guide for help finding the correct replacement.

Can I replace only one Lenco trim tab actuator?

A single actuator may be replaced when the new actuator matches the existing trim tab system and the actuator on the opposite side is still operating correctly. Inspect both actuators, the trim tab blades, wiring, controls, and mounting hardware before completing the repair.

What should I verify before ordering the Lenco 15120-001?

Confirm the existing actuator model, stroke length, system voltage, wire length, mounting-hole sizes, and replacement part number. Do not select a replacement based only on appearance.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov