Quicksilver 92-802878Q55 Corrosion Guard

Quicksilver 92-802878Q55 Corrosion Guard

Quicksilver Corrosion Guard is a rust inhibitor that forms a water resistant barrier on non-painted and painted surfaces. Use to prevent rust from forming on outdrives, lower units, and power trim motors and components or other metal surfaces. Can also be used to prevent further paint damage in areas where undercutting and blistering have occurred. 

Features:

• 11 oz. spray can
• Absorbs moisture and airborne chemicals to protect against rust and corrosion
• Forms a water-resistant barrier for added protection
• Remains clear and doesn't peel
• Safe for all painted surfaces

Do not spray on surfaces coated with antifouling or biocide paint. Do not spray on drive belts.

How to Apply Quicksilver Corrosion Guard:

Use when air and can temperature is between 50°F and 80°F and humidity is 60% or less. Avoid spraying in very windy, dusty conditions. Cover surrounding area to protect from spray mist.

• Remove all dirt, wax, grease, saltwater deposits, and other contaminants with a high quality cleaner.
• Rinse with water and allow area to dry.
• Shake can vigorously for one minute after mixing ball begins to rattle. Shake often during use.
• Hold can upright 8-10" from surface and apply thin, even coats using a steady back and forth motion.
• Note: Keep the can in motion while spraying; release button after each stroke.
• Dries to the touch in 20 minutes, to handle in 1 hour, and fully dry in 24 hours.
• Reapply before storing your boat and every week if boating in salt water areas.

When finished spraying, clear spray valve by turning can upside down and pushing spray button until clear gas comes out. Clean up wet paint with mineral spirits. Dispose of empty can in accordance with local, state, and federal regulations.

Frequently Asked Questions

What is Quicksilver 92-802878Q55 Corrosion Guard used for?

Quicksilver 92-802878Q55 Corrosion Guard is a rust inhibitor designed to protect painted and non-painted surfaces from rust and corrosion. It can be used on outdrives, lower units, power trim motors and components, and other metal surfaces. It also helps prevent further paint damage where undercutting and blistering have occurred.

What surfaces can Quicksilver Corrosion Guard be applied to?

Quicksilver Corrosion Guard forms a water-resistant barrier on painted and non-painted surfaces and is safe for all painted surfaces. Do not apply it to surfaces coated with antifouling or biocide paint, and do not spray it on drive belts.

How should Quicksilver Corrosion Guard be applied?

Clean the surface to remove dirt, wax, grease, saltwater deposits, and other contaminants, then rinse and allow it to dry. Shake the can vigorously and apply thin, even coats from 8–10 inches away while keeping the can moving. Apply when the air and can temperature is 50°F–80°F with humidity of 60% or less.

How long does Quicksilver Corrosion Guard take to dry?

Quicksilver Corrosion Guard dries to the touch in 20 minutes, is ready to handle in 1 hour, and fully dries in 24 hours. Drying times are based on the application directions provided for the product.

How often should Quicksilver Corrosion Guard be reapplied?

Quicksilver recommends reapplying Corrosion Guard before storing your boat. When boating in saltwater areas, the product should be reapplied every week according to the supplied application directions.

What should I do after spraying Quicksilver Corrosion Guard?

After spraying, clear the spray valve by turning the can upside down and pressing the spray button until clear gas comes out. Wet paint can be cleaned up with mineral spirits. Empty cans should be disposed of according to applicable local, state, and federal regulations.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov