Welcome to WholesaleMarine.com

Call Toll-Free: M-F 9AM - 6PM EST

Pettit Transducer Antifouling Spray Paint

Be the first to review this product

SKU: PET-1793
Availability: In Stock - Ships Today
Shipping Restrictions: Ground Only To Contiguous 48 States
Order within and your order ships today! Details

Availability: In stock


Our Price $23.87

Pettit Paint
Recent Customer Feedback

Product Description

Transducer Paint 1793 is for use only on plastic transducer housings and bare metals including steel, stainless steel, cast iron, copper, bronze, galvanized steel and lead. It forms an excellent adhesive bond to underwater plastic housings and metals, and inhibits corrosion on these surfaces. Transducer Paint's smooth, hard surface will self -clean in service, and can be used above or below the waterline. The dried film of Transducer Paint contains 93% pure zinc.

  • Superior transducer and underwater metal protection
  • Excellent adhesion to clean metals and plastic transducer housings
  • 93% pure zinc in the dried film
  • Fast dry formula in an easy to use aerosol spray can

Not for use on aluminum, fiberglass or wood. 

Additional Information

Manufacturer Pettit Paint
Manufacture Part Number 1793
UPC 725469001350


Write Your Own Review

You're reviewing: Pettit Transducer Antifouling Spray Paint

    1 star
    2 stars
    3 stars
    4 stars
    5 stars

* Required Fields

How to Apply


Application Method: Aerosol Spray

Number of Coats: 2 or 3

Note: Do not apply more than three coats as cracking and loss of adhesion may occur if product is applied too thick or in too many coats.

Application Temp: 50°F Minimum | 90°F Maximum

Application Humidity:  0% RH Minimum | 85% RH Maximum

Coverage: 10 sq. ft/16 oz. spray can

Temp    To Recoat (Hours) To Launch (Hours)
90°F 1/2 16
70°F 1 24
50°F 2 48


Underwater Metals

  • Remove all paint from underwater metals, running gear, and plastic transducer housings by sanding, scraping, sandblasting or by using a paint and varnish remover.

Note: Do not use any solvent or paint and varnish remover containing ketone type solvents such as acetone, methylethyl ketone or methyl isobutyl ketone as these solvents will destroy the plastic transducer housing.

  • Once back to bare, clean metal, wipe the surface with Pettit 120 Brushing Thinner and let dry.

Metals above Water

  • Remove all paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
  • Clean surface with Pettit 120 Brushing Thinner and let dry.


  • Shake can vigorously for two minutes after the mixing balls begin to rattle.

Shake often during use

  • Hold can upright 12 to 16 inches from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Be sure to keep the can the same distance from the surface and in motion while spraying.

Note: Allow no more than 5 minutes between two or three thin coats. Otherwise, allow to dry one hour before applying additional coats.

  • When finished spraying, clear spray valve by turning can upside down and spraying until no more paint comes out. If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits.

Do not stick a pin or other object in the stem


 Information sourced from Pettit Tranducer Paint 1793 Technical Bulletin 159

You May Also Like