BoatLife "Git"-Rot Epoxy Kit
BoatLife "Git" Rot system is great for tackling dry rot because it works without having to remove dry rotted fibers. Unique two-part liquid epoxy saturates and restores original strength to wood by penetrating the rot. Wood must be dry for application. Apply by injecting "Git" Rot Epoxy into the wood. The epoxy will soak into wood by capillary action.
- Cures overnight
- Sandable and paintable, can be drilled and screwed
- Compatible with fiberglass resins, epoxies and most sealants
- Great for transoms, stringers and cabin roof rot in both fiberglass and wood boats
***WILL SHIP GROUND ONLY TO THE CONTIGUOUS 48 STATES ONLY***
How to Use BoatLife "Git"-Rot Epoxy
For complete saturation and ultimate strength (in average type rot), it will require a volume of "Git"-Rot approximately equal to half the volume of the rotted wood.
- Provide Reservoirs
- Where rot is deep into a large member, it is advisable to drill a staggered series of overlapping holes approximately 1/4" in diameter, 2" apart, slanting downwards. This will expose the necessary end grain and provide reservoirs for the penetration.
- In areas where sections of rot contain extensive holes where wood fibers are actually missing, it is recommended to mix sawdust with "Git"-Rot and use it as a fill material.
- In areas such as transoms, stringers, and balsa core decking, drilling thru the fiberglass surface may be necessary. For transom repairs, you may drill vertically down through the transom, and then pour in "Git"-Rot.
- For decking, drill thru the surface to treat the wood underneath. Holes left by drilling may be filled with a mixture of dry saw dust and "Git"-Rot or a marine repair epoxy compound.
- The most expedient way to apply "Git"-Rot epoxy is into the end grain of the wood wherever possible.
- To avoid trapping air in the middle of the rot, always start at one end or on one surface and work progressively along.
- Continue until complete saturation is achieved. *This is determined when the reservoir holes fill and remain filled, and the surface remains shiny
"Git"-Rot will eventually cure into damp wood, however wet wood cannot be fully saturated. Be sure to dry the area as much as possible before application.
Customers also viewed