Jabsco Shower Drain and Bilge Pump
Flow rate: Nominal 13 Litres/min (3 USgallons/min)
Self-priming from dry up to 2m (6ft)
Flow Rate: 3 GPM, Port Size: 3/4"
Nominal Voltage: 12 Volt DC, Max. Current Draw: 8 Amps, Fuse: 10 Amp
Ignition Protected, Supplied with Pumpgard StrainerQuiet running and fully corrosion resistant.
Supplied with pumpgard filter.
- Permanent magnet motor
- Compact and simple design
- Dry running capability
- Permanent magnet type motor
- Meets ISO 8846 MARINE ignition protection
- Fit pump in a dry position, as close as possible to the liquid being pumped, where there is full access to the pump for service.
- Use 3/4" i.d. spiral reinforced hose (with a smooth internal bore), or semi-rigid pipework systems.
- Note: Pipe runs should be as straight and as short as possible, avoiding riding and dipping over obstructions.
- Fit pumpguard on inlet side of pump.
- All marine pumps discharging overboard must be installed with the overboard discharge well above both static and heeled waterlines (Sailboats normally discharge through the transom).
- Motor cases may get hot. Prolonged contact during operation may cause burns.
- Note: Do not use for pumping petrol, petroleum products, or fluids with flash points below 98.6 degrees Fahrenheit.
Google Product Type:
Customers also viewed